Table of Contents
Advertisement
Attention:
The operator panel cable and attention light cable
could be damaged upon removing the cover group. Make sure
they are free from snagging before the next step.
7. Standing in front of the printer, grasp 1 side-cover hand-hold
and spread the cover group, pulling it up and over the edge of
the base.
8. Grasp the other side-cover hand-hold and do the same.
The cover group is now sitting on the top of the base.
9. Grasp both hand holds and carefully lift forward and up to
remove the cover group.
Installation notes:
Attention:
The operator panel cable assembly uses a splice
connector/cable to increase its length. Be sure to properly
connect the splice connector or damage to the operator panel will
occur on power up.
Perform the tear-off line adjustment. See Tear-off line.
Chapter 5. Removals, service checks and adjustments
184
Advertisement
Chapters
Table of Contents
