"About Power Button and Keyswitch Settings" on page 14
■
"About Setting Up a Console" on page 16
■
"Locating Rear Panel Features" on page 25
■
"Tools Required for Installation and Service" on page 28
■
How to Power On the System
Before You Begin
Do not use this power-on procedure if the operating system is already installed and
you have just added a new internal option or external storage device. To power on
the system after adding one of these options, see:
"How to Initiate a Reconfiguration Boot" on page 10
■
What to Do
Caution – Never move the system when the system power is on. Movement can
cause catastrophic disk drive failure. Always power off the system before moving it.
Caution – Before you power on the system, make sure that the front and side doors
and all plastic outer panels are properly installed.
1. Turn on power to any peripherals and external storage devices.
2. Turn on power to the alphanumeric terminal or local graphics console, if present.
2
Sun Fire V890 Server Service Manual • October 2005