Sun Microsystems Fire V890 Service Manual page 317

13. Change the enclosure name of one of the FC-AL backplanes. Type the
luxadm enclosure_name command.
Each backplane must have a unique enclosure name. Use the luxadm
enclosure_name command to assign a unique name by changing one of the
enclosure names as shown in the following example.
To change the enclosure name, assign the new name (FCloop2 in the example) and
enter the path name (/dev/es/ses2 in the example) of the appropriate backplane.
You obtained the path name from the output from the luxadm probe command
shown in Step 12. You can enter either of the path names (/dev/es/ses2 or
/dev/es/ses3) shown in
# luxadm enclosure_name FCloop2 /dev/es/ses2
Note – There is no output from the luxadm enclosure_name command.
14. Verify that the Solaris software recognizes the correct enclosure name for each
backplane. Type the luxadm probe command.
Notice that the output example now shows a unique name (FCloop and FCloop2 in
the example) for each backplane.
# luxadm probe
Found Enclosure(s):
SUNWGS INT FCBPL
Logical Path:/dev/es/ses0
Logical Path:/dev/es/ses1
SUNWGS INT FCBPL
Logical Path:/dev/es/ses2
Logical Path:/dev/es/ses3
Step 12.
Name:FCloop
Name:FCloop2
Appendix C
Node WWN:5080020000197378
Node WWN:5080020000197548
Split Backplane Configurations 289