Sun Microsystems Fire V890 Service Manual page 209

2. Fasten the three screws and nylon washers that secure the backplane to the disk
cage.
3. Connect the disk status flex circuit cables to the base backplane at connectors
J01001 and J01000.
4. If the expansion FC-AL backplane is installed, connect the following cables:
For cable connector locations, see
a. FC-AL data cable (C and D) from connectors C(J01100) and D(J01101) on the
expansion backplane to the base backplane at connectors H(J01103) and
G(J01102)
a. FC-AL data cable (A and B) from connectors A(J0201) and B(J0200) on the
expansion backplane to the base backplane at connectors F(J0501) and E(J0500)
5. To reassemble the system, complete these tasks:
a. "How to Install the FC-AL Disk Cage" on page 189
b. "How to Install the CPU Fan Status Assembly" on page 60
c. "How to Install a CPU Fan Tray" on page 50
"Cable Connector Locations" on page
Chapter 6 Removing and Installing Backplanes and Cables
212.
181