Sun Microsystems Fire V890 Service Manual page 305

8. Install the primary and secondary I/O fan trays. (See
Tray" on page 78
interfere with the fans. If necessary, use tie-wraps to attach the cable to the
internal wall near the backplanes.
Caution – Be sure that the cable plug you removed from connector J0801 does not
interfere with the fans. You can use the cable fasteners on the internal wall near the
expansion backplane to bundle the cable plug with the cables routed along the
internal wall.
Caution – Before you power on the system, be sure that the front and side doors
and all plastic outer panels are properly installed.
9. Power on the system and access the ok prompt.
See "How to Initiate a Reconfiguration Boot" on page
10. Verify that all disks and network adapters are recognized by the OpenBoot
PROM. At the ok prompt, type the probe-scsi-all command.
ok probe-scsi-all
/pci@9,600000/pci@1/SUNW,qlc@5
/pci@9,600000/pci@1/SUNW,qlc@4
LiD HA LUN --- Port WWN ---
2 2 0 21000004cfce7fa0
6 6 0 5080020000197549
3 3 0 2100002037e758d3
4 4 0 21000004cfce7fca
5 5 0 21000004cfce7fc4
0 0 0 21000004cfce7fc8
1 1 0 21000004cfce7fd5
/pci@8,600000/SUNW,qlc@2
LiD HA LUN --- Port WWN ---
0 0 0 21000004cfce8257
1 1 0 21000004cfce7fd3
for instructions.) Check that the FC-AL data cable does not
"How to Install an I/O Fan
10.
----- Disk description -----
SEAGATE ST336752FSUN36G 0408
SUNW SUNWGS INT FCBPL922A
SEAGATE ST336704FSUN36G 0726
SEAGATE ST336752FSUN36G 0408
SEAGATE ST336752FSUN36G 0408
SEAGATE ST336752FSUN36G 0408
SEAGATE ST336752FSUN36G 0408
----- Disk description -----
SEAGATE ST336752FSUN36G 0408
SEAGATE ST336752FSUN36G 0408
Appendix C Split Backplane Configurations 277