Sun Microsystems Fire V890 Service Manual page 179

8. Connect the appropriate plug (P2 or P3) of the Ultra Wide SCSI data cable (Sun
part number 530-3302) to the back of the tape drive.
For proper plug connections, see
9. Route the SCSI data cable and connect the cable to the SCSI adapter card (Sun
part number X6758A).
Route the cable over the I/O fan tray brackets and down the PCI fan block bracket
to the middle routing lance. Use tie wraps to secure the cable to the PCI fan block
bracket.
Note – Because of the size of the SCSI connector, the SCSI host adapter card must be
installed in PCI slot 0.
10. Connect plug P1 of the cable to the 68-pin SCSI connector on the SCSI host
adapter card.
"Cable Routing" on page
Chapter 4 Removing and Installing Storage Devices
215.
151