What Next - Sun Microsystems Fire V890 Service Manual

5. Slide the fan tray you are removing out of the system.
6. If you disconnected the cable to fan tray 6 to remove fan tray 5, reconnect the
cable to fan tray 6.
If you disconnected the cable to fan tray 6 as part of a hot-swap procedure for fan
tray 5 and you are immediately replacing fan tray 5, do not reconnect the cable to
fan tray 6 until you install fan tray 5.

What Next

Note – During a hot-swap operation, after you remove a fan tray or power supply,
wait for an acknowledgement message on the system console before installing a
replacement part; otherwise, the environmental monitoring software will not
recognize the new device and false error conditions will result.
To replace the motherboard fan tray, complete this task:
"How to Install a Motherboard Fan Tray" on page 55
■
To reassemble the system, complete this task:
"How to Close a Side Door" on page 23
■
54 Sun Fire V890 Server Service Manual • October 2005