What Next - Sun Microsystems Fire V890 Service Manual

3. Tighten the two captive screws that secure the power supply to the chassis.
4. Connect the AC power cord to both the power supply and a dedicated AC power
outlet.
Insert the female end of the power cord through the strain-relief tie-wrap loop
located to the right of the supply. Tighten the tie-wrap to secure the connection.

What Next

If you installed this part as a new option while the system was powered off, you
need to perform a reconfiguration boot. A reconfiguration boot is required in order
for the operating system to recognize the new device. See:
"How to Initiate a Reconfiguration Boot" on page 10
■
162 Sun Fire V890 Server Service Manual • October 2005