What Next; How To Remove The System Id Prom; Before You Begin - Sun Microsystems Fire V890 Service Manual

3. Connect the I/O fan status cable (P27) to the connector on the back of the flex
circuit.

What Next

To reassemble the system, complete this task:
"How to Close a Side Door" on page 23
■

How to Remove the System ID PROM

This section explains how to remove a functioning ID PROM module so that you can
install it on a new I/O board, thereby preserving the system's host ID information. If
you are replacing a defective ID PROM module and want to retain the same host ID
and Ethernet address, consult your authorized Sun sales representative or service
provider for assistance with programming the new ID PROM with the existing host
ID and Ethernet address.

Before You Begin

Complete these tasks:
"How to Power Off the System" on page 5
■
"How to Open and Remove a Side Door" on page 21
■
"How to Avoid Electrostatic Discharge" on page 26
■
112 Sun Fire V890 Server Service Manual • October 2005