Sun Microsystems Fire V890 Service Manual page 307

13. Change the enclosure name of one of the FC-AL backplanes. Type the
luxadm enclosure_name command.
Each backplane must have a unique enclosure name. Use the luxadm
enclosure_name command to assign a unique name by changing one of the
enclosure names as shown in the following example.
To change the enclosure name, assign the new name (FCloop2 in the example) and
enter the path name (/dev/es/ses2 in the example) of the appropriate backplane.
You obtained the path name from the luxadm probe command output shown in
Step 12.
# luxadm enclosure_name FCloop2 /dev/es/ses2
Note – There is no output from the luxadm enclosure_name command.
14. Verify that the Solaris software recognizes the correct enclosure name for each
backplane. Type the luxadm probe command.
Notice that the output example now shows a unique name (FCloop and FCloop2 in
the example) for each backplane.
# luxadm probe
Found Enclosure(s):
SUNWGS INT FCBPL
Logical Path:/dev/es/ses0
SUNWGS INT FCBPL
Logical Path:/dev/es/ses2
Name:FCloop Node WWN:508002000017c4d8
Name:FCloop2 Node WWN:50800200001cb798
Appendix C Split Backplane Configurations 279