What Next; How To Remove The Sun Storedge Pci Dual Fibre Channel Host Adapter Card; Before You Begin; What To Do - Sun Microsystems Fire V890 Service Manual

What Next

The system controller hardware runs Remote System Control (RSC) software. After
replacing the system controller card, you must restore the RSC configuration settings
by running the RSC server configuration script. In addition, the replacement card
has a new Ethernet MAC address, which may necessitate configuration changes to
other network devices. To determine the Ethernet MAC address for the new system
controller card, use the RSC shell command shownetwork. For more information,
refer to the Remote System Control (RSC) 2.2 User's Guide, which is available on the
Sun Fire V890 Documentation CD.
To reassemble the system, complete this task:
"How to Close a Side Door" on page 23
■
How to Remove the Sun StorEdge PCI
Dual Fibre Channel Host Adapter Card
For information about FC-AL host adapters, refer to your Sun Fire V890 Server
Owner's Guide.

Before You Begin

Complete these tasks:
"How to Power Off the System" on page 5
■
"How to Open and Remove a Side Door" on page 21
■
"How to Avoid Electrostatic Discharge" on page 26
■

What to Do

1. Locate the Sun StorEdge PCI Dual Fibre Channel Host Adapter card.
2. Disconnect any internal and external cables attached to the card.
94 Sun Fire V890 Server Service Manual • October 2005