What Next; How To Remove The Fc-Al Disk Cage; Before You Begin - Sun Microsystems Fire V890 Service Manual

Note – For more information about the luxadm utility, refer to Platform Notes: Using
luxadm Software, which is included on the Sun Fire V890 Documentation CD.
10. Once the firmware synchronization process is complete, you can restore the
system to multiuser mode.
For example, type:
# init 3

What Next

If you installed this part as a new option, you need to perform a reconfiguration
boot in order for the operating system to recognize the new device. See:
"How to Initiate a Reconfiguration Boot" on page
■
Note – Be sure to run POST and OpenBoot Diagnostics tests to verify that the
system functions correctly with the parts you have just installed. Refer to OpenBoot
PROM Enhancements for Diagnostic Operation on the Sun Fire V890 Documentation
CD.

How to Remove the FC-AL Disk Cage

Before You Begin

Complete these tasks:
"How to Power Off the System" on page 5
■
"How to Open and Remove a Side Door" on page 21
■
"How to Avoid Electrostatic Discharge" on page 26
■
"How to Remove a Disk Drive" on page 133
■
from the disk cage)
"How to Remove an I/O Fan Tray" on page 76
■
trays)
"How to Remove a CPU Fan Tray" on page 48
■
"How to Remove the CPU Fan Status Assembly" on page 57
■
(you must remove all the disk drives
Chapter 6 Removing and Installing Backplanes and Cables
10.
(you must remove both I/O fan
183