Reference For Pci Slot Locations - Sun Microsystems Fire V890 Service Manual

3. Remove the primary and secondary I/O fan tray assemblies.
See "How to Remove an I/O Fan Tray" on page 76
4. Disconnect the following cables (if installed) from the expansion backplane and
the base backplane:
For cable connector locations, see
Locations" on page
a. Base/expansion cable from both base and expansion backplane connectors
J0801.
b. FC-AL data cable from base backplane connectors J01103 and J01102, and from
expansion backplane connectors J01101 and J01100.
c. FC-AL data cable from expansion backplane connectors J0201 and J0200, and
from base backplane connectors J0501 and J0500.
5. Choose a slot for the PCI Dual FC Network Adapter.
For higher throughput, select one of the 66-MHz slots (PCI slot 7 or 8). See
"Reference for PCI Slot Locations" on page
6. Install the PCI Dual FC Network Adapter.
See "How to Install a PCI Card" on page 83
The PCI Dual FC Network Adapter contains two external optical transceiver
connectors, located on the spine of the adapter. Pull the dust cover from each
external connector before you install the adapter.
After you install the network adapter, replace the dust cover on the Port 1 connector.
In this configuration, Port 1 of the network adapter cannot be used to connect to
external devices. Use only Port 2 to connect to external devices.
7. Connect the new FC-AL data cable (P3 and P4) to connectors J3 (P3) and J4 (P4) on
the PCI Dual FC Network Adapter and to expansion backplane connectors (C)
J0200 and (D) J0201.
See "Reference for Cable Routing and Connector Locations" on page 293
reference for cable connections
"Reference for Cable Routing and Connector
293.
Appendix C
for instructions.
296.
for PCI card installation instructions.
Split Backplane Configurations
for a quick
275