What To Do - Sun Microsystems Fire V890 Service Manual

What to Do

1. Locate the PCI slot for the Sun StorEdge PCI Dual Fibre Channel Host Adapter
card.
Note – For optimal performance, install the Sun StorEdge PCI Dual Fibre Channel
Host Adapter card into a 66-MHz PCI slot (slot 7 or 8) on the I/O board. The Sun
StorEdge PCI Dual Fibre Channel Host Adapter card will function in a 33-MHz or
66-MHz PCI slot. For more information about PCI slots, see
Buses" on page 225.
2. If a PCI filler panel is installed in the slot's rear panel opening, remove it.
a. Pinch the PCI card retaining clip until it releases from the top of the filler panel
and rotate the clip outward.
b. Slide the filler panel out from the rear panel.
3. Connect the Sun StorEdge PCI Dual Fibre Channel Host Adapter FC-AL cable to
the card.
a. Connect the cable end labeled P3 to connector J3 on the card.
b. Connect the cable end labeled P4 to connector J4 on the card.
4. Insert the Sun StorEdge PCI Dual Fibre Channel Host Adapter card into its slot on
the system I/O board.
a. Insert the faceplate end of the card into the appropriate opening in the rear
panel.
b. Push the card into the connectors on the system I/O board.
Apply even pressure along the edge of the card.
Chapter 3 Servicing the Input/Output Board Side Components
"About PCI Cards and
99