12. If you are performing a hot-plug installation, complete the software part of the
installation procedure.
See
"About Hot-Pluggable and Hot-Swappable Components" on page
Note – If you are installing more than one disk drive as part of a hot-plug
procedure, make sure that the Activity LED on the drive you just installed is lit
steadily (that is, not flashing) before installing another disk drive. For more
information about disk drive LEDs, see
What Next
If you installed this part as a new option while the system was powered off, you
need to perform a reconfiguration boot. A reconfiguration boot is required in order
for the operating system to recognize the new device. See:
"How to Initiate a Reconfiguration Boot" on page 10
■
How to Remove the DVD-ROM Drive
Before You Begin
Complete these tasks:
"How to Power Off the System" on page 5
■
"How to Open and Remove a Side Door" on page 21
■
"How to Avoid Electrostatic Discharge" on page 26
■
138
Sun Fire V890 Server Service Manual • October 2005
"About Disk Drive LEDs" on page
6.
267.