Sun Microsystems Fire V890 Service Manual page 129

6. If you are installing the card for the first time, route and connect the Sun StorEdge
PCI Dual Fibre Channel Host Adapter FC-AL cable in the system in the following
manner:
a. Attach the three tie wraps provided with the Sun StorEdge PCI Dual Fibre
Channel Host Adapter FC-AL cable onto the lances on the chassis power bay
cover.
Attach the tie-wraps onto
these lances
b. Route the cable down to the chassis power bay cover and through the three
tie-wraps.
Leave enough slack in the cable so that you can remove any other installed PCI
cards during a PCI hot-plug procedure.
For cable connector locations, see
c. Connect the cable end labeled D to connector D on the base FC-AL backplane.
d. Connect the cable end labeled C to connector C on the base FC-AL backplane.
"Cable Connector Locations" on page
Chapter 3 Servicing the Input/Output Board Side Components
212.
101