Sun Microsystems Fire V890 Service Manual page 234

2. Connect the following cables to the power distribution board:
For cable connector locations, see
a. Motherboard power cables (P7A and P7B) to the power distribution board at
connectors P7/J4 and P7/J11(MOTHERBOARD)
b. I/O board remote sense cable (P38) to the power distribution board at connector
P38/J10(Sense/5Vstby)
3. Carefully finish positioning the power distribution board in the chassis against its
bracket.
a. Align the board by placing the bracket side of the board against the power
distribution board bracket so that the hole on the top of the board aligns with
the tab on the centerplane.
This ensures that the tabs on the end of the power distribution board are aligned
with their cutouts in the sidewall of the chassis.
206 Sun Fire V890 Server Service Manual • October 2005
"Cable Connector Locations" on page 212.