What Next; How To Remove The Pci Internal Led Flex Circuit; Before You Begin; What To Do - Sun Microsystems Fire V890 Service Manual

What Next

To reassemble the system, complete this task:
"How to Close a Side Door" on page 23
■
If you installed this part as a new option, you need to perform a reconfiguration
boot in order for the operating system to recognize the new device. See:
"How to Initiate a Reconfiguration Boot" on page 10
■
Note – Be sure to run POST and OpenBoot Diagnostics tests to verify that the
system functions correctly with the parts you have just installed. Refer to OpenBoot
PROM Enhancements for Diagnostic Operation on the Sun Fire V890 Documentation
CD.
How to Remove the PCI Internal LED
Flex Circuit

Before You Begin

Complete these tasks:
"How to Power Off the System" on page 5
■
"How to Open and Remove a Side Door" on page 21
■
"How to Avoid Electrostatic Discharge" on page 26
■

What to Do

1. Disconnect the PCI internal status cable (P37) from the back of the PCI internal
LED flex circuit.
102 Sun Fire V890 Server Service Manual • October 2005