Sun Microsystems Fire V890 Service Manual page 165

5. Release the drive handle on the disk drive to be installed.
Use your thumb and forefinger to pinch the drive latch upward to open it.
6. Align the disk drive with its drive bay.
Orient the drive so that the drive handle's hinge faces the bottom of the drive bay.
7. Holding the drive by its handle, fit the drive into the guide rails at the top and
bottom of the drive bay.
8. Slide the drive into the bay until it barely contacts the backplane.
9. Press carefully on the center of the drive and watch as the handle begins to close.
The drive handle begins to close as the drive engages its backplane connector.
10. Press the handle toward the drive until the latch closes, securing the drive
in place.
11. Close the front door and lock it, if necessary.
Chapter 4 Removing and Installing Storage Devices 137