Leading Edge Skew Adjustment - Xerox Phaser 6115MFP Service Manual

Leading Edge Skew Adjustment

Phaser 6115MFP Multifunction Product Service Manual
Procedure:
1. Prepare a chart (A4S or 11 x 8 1/2S) by drawing a reference line on a
sheet of paper at a position 20 mm away from the edge as illustrated
below.
Width B: 20 mm
2. Enter the SERVICE MODE.
3. Select [ADF FD REGIST] of [1 ADJUST] and press the Menu/Select key.
4. Load the test chart in the ADF and press the Start key.
5. Measure the length of width B on the copy to check that it falls within the
specified range.
6. Press the Menu/Select key, adjust the setting value using the +/- key, and
then press the Menu/Select key to validate the setting.
7. Repeat steps 4 through 6 until the length of width B falls within the
specified range.
8. If dimension B on the copy falls outside the specified range:
a. Increase the setting value if dimension B falls short of the specified
range.
b. Decrease the setting value if dimension B exceeds the specified
range.
Adjusts problems associated with leading skew images.
When to Use:
when image skew occurs.
Specification:
10mm +/- 2.0mm
Adjustments and Print Function Settings
s6115-363
6-53