Chrysler 2005 Crossfire SRT6 Service Manual page 290

5 - 124 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1022-NO CAN COMMUNICATIONS WITH PCM (CONTINUED)
2.
MEASURE THE RESISTANCE OF THE CAN C BUS (-) CIRCUIT
With the ignition off.
Measure the resistance of the CAN C Bus (-) circuit from the CAB har-
ness connector to the PCM harness connector.
Is the resistance below 1.0 ohm?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the CAN C Bus (-) circuit for an open.
Perform ABS VERIFICATION TEST.
ANTILOCK BRAKE -
ZH