Frame, Main, Pf Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

4.2.5.14 Frame, Main, PF Removal

1. Remove Carriage Unit.(See section 4.2.5.10)
2. Remove "Frame, Main, Paper Eject". (See section 4.2.5.11)
3. Remove "Paper Guide Upper Unit". (See section 4.2.5.12)
4. Remove 2 CBS(3x6) screws securing "Frame, Main, PF" to "Frame,
Middle, Left", and remove "Frame, Main, PF". (Refer to Figure4-51)
T T
9
CHECK POINT
When re-installing "Frame, Main, PF", insert ink
valve driven gear and driven axis for PG change
into each corresponding holes on the "Frame,
Main, Left".(Refer to Figure4-52)
T T
There is a bush to fix the ink valve driven gear to
"Frame, Main, Right". Therefore, when installing,
make sure to push the protrusion of the bush to
the hole on the "Frame, Main, Left".
(See Figure5-52)
Rev. A
"Frame,Main, Left"
Figure 4-51. Frame, Main, PF Removal
Driven Axis for PG Change
Figure 4-52. Points when re-installing "Frame, Main, PF"
Chapter4 Assembly and Disassembly
"Frame, Main, PF"
CBS(3x6)
Ink valve driven gear
Hole to insert
the protrusion
of bush
Protrusion of bush
4-28