Epson Stylus Pro 5000 Service Manual page 88

Stylus Pro5000
5. Release each 2 fixing parts of "Cover, CR, Front" located rear and front,
and release "Cover, CR, Front". (Refer to Figure4-20)
6. Pull out each 6 dampers from the head needle.
CAUTION
Total 6 dampers are fixed in the order(from left);
Bk→ → Cyan→ → Magenta→ → Light Cyan→ → Light Magenta
→ → Yellow.
WARNING
Since the print head is not strong against static
electricity, wear rubber glove.
7. Remove each one CBB screw(2.5x6) securing left and right head to the
carriage and plain washer(3.4x1.0x8.2x2).
8. Remove "Compression Spring,9.9" pressing left and right head to the
carriage side. (Refer to Figure4-21)
9
CHECK POINT
Even after releasing the fixing part of head, if the
head can not be removed easily, pull the parts
marked with arrow in the figure 4-21 so that the
head can be removed easily.
Rev.A
"Cover, CR, Front"
Figure 4-20. Releasing "Cover, CR, Front"
"Compression Spring,9.9"
Screw with plain
Screw with plain
washer for fixing
washer for fixing
left head.
right head.
Figure 4-21. Print Head Removal(1)
Chapter4 Assembly and Disassembly
Fixing Hooks(each at both right and left sides)
4-12