Epson Stylus Pro 5000 Service Manual page 319

5
Checking the RIP Station 5000 as a stand-alone unit
5. At the DIAGNOSTIC MIX screen (only appears if you selected more than one test and you
selected Time..., Failure, or Interrupted for the RUN UNTIL option), select the
percentage of repetition for each test and then press the menu button. If you select the
Equal Times option the tests begin running immediately.
Use the line selection buttons next to each test to change the percentage of repetition for
each test (percentages are available in increments of ten). To scroll through the list, use
the up and down button. If you want to run all tests for an equal amount of time, select
the
Equal Times
Note: If you change the percentage of repetition for the Custom tests, make sure that at
least one of the tests has a value of 100%.
6. If any of the tests fail, check the Details option in the diagnostic report for more
information about the failing test (see "Viewing the diagnostic report" on page 5-18).
Then shut off the RIP Station 5000, and perform the recommended service for the failed
test or replace the failed component.
7. If the Custom diagnostics all pass, the Control Panel indicates that all tests passed.
Press the menu button to restart the RIP Station 5000.
option.
5-15