Epson Stylus Pro 5000 Service Manual page 272

4
Connector bracket
Mounting screws (3)
Center frame hooks (3)
EMI bottom shield
(not shown)
4-16
Service Procedures
Motherboard
The custom RIP Station 5000 motherboard has a 133MHz CPU and a minimum of
32MB of memory. It processes image data, controls hard disk drive functions, and
handles communication between the RIP Station 5000 and external devices.
This section includes instructions for replacing the motherboard and also for replacing
the battery and DIMMs on the motherboard.
Removing the RIP Station 5000 motherboard
The motherboard attaches to the RIP Station 5000 center frame. Before you remove the
motherboard, you must remove:
• Power, UIB, HDD, and fan cables attached to the motherboard
• Option board, if present
The connector bracket remains attached to the motherboard.
Removing the motherboard
F 4-13
IGURE
Power supply cable
Center frame
Fan cables
Pin 1 (red stripe)
HDD ribbon cable
EMI main shield
UIB cable