Epson Stylus Pro 5000 Service Manual page 146

Stylus Pro5000
T T
WARNING
It is necessary to have the new ink cartridge in
advance, in case of performing the ink initial
charge forcefully.
Table 5-1.Adjustment Items
No. Contents Category
of
Operation
1 Head Adjustment Program
Exchange (Maintenance)
Adjustment Program
(Adjustment)
2 C228 DRV Adjustment Program
Board (Adjustment)
Exchange
3 C228 Main Upload Program
Board
Exchange
4 CR(Guide Mechanism
Axis) Adjustment
Exchange
Rev. A
The Order Required
of Adjustment Item
operation
1 Reset the initial
ink charge flag
2 Head Voltage
Value
Adjustment
3 Head Angular
Adjustment
4 Head Height
Adjustment
5 Head Gap
Adjustment
6 Bi-D Adjustment
1 Re-input the
model name
2 Head Voltage
Value
Adjustment
3 Head Gap
Adjustment
4 Bi-D Adjustment
1 Uploading the
firmware
1 Parallelism
Adjustment
Table 5-2. Adjustment Items(Cont.)
No. Contents of Category
Operation
5 Operation for Adjustment
Clogging Program
Recovery
(Maintenance)
•Adjustment
6 Waste Ink
Pad
Program
Exchange
(Maintenance)
•Alternative
function on the
control panel
7 Upper Mechanism
surface Adjustment
Sensor
Exchange/
Removal
8 CR Motor Adjustment
Exchange Program
CAUTION
In order to clear the value of the waste ink pad
counter, you can do it either by the exclusive
program (service program) or by alternative
function on the control panel. It is necessary to
install the new ink cartridges, in case of clearing
the value from the control panel, since the values
of the ink end counter are also cleared at the same
time.
Chapter5 Adjustment
The Order Required
of Adjustment
operation
1 Head Cleaning*1
2 Reset of initial ink
charge flag (If it
does not recover
by performing *1)
1 Clear the waste
ink pad counter
value by the
exclusive
program service
program) or
alternative
function from the
control panel
1 Upper surface
Sensor
Positioning
Adjustment
1 Head Gap
Adjustment
2 Bi-D Adjustment
5-2