Epson Stylus Pro 5000 Service Manual page 312

5
Possible errors during Start-up diagnostics
T 5-1
ABLE
Error
Test name
Number
RTC Self Test 700
RTC R/W Reg 710
RTC Start 720, 730
RTC Set 740
ENET SLV REG 400, 401
IDE Chip 1001
MEM DIMM INFO 300
MEM ADDRESS 301
SERIAL CHIP 3000, 3001
SCSI Reg 630
5-8
Troubleshooting Procedures
Area tested
on motherboard
Real Time Clock chip
Ethernet controller chip
Note:
Also check the DIMMs.
EIDE controller chip
DIMMs on the motherboard and chip
holding DIMM info
PCI bus and I/O controllers
SCSI controller chip
Suggested action
• Replace the battery on the motherboard.
• Replace the motherboard.
• Check DIMMs.
• Have network administrator verify network.
• If this does not correct the problem, you may
need to replace the motherboard.
• Replace the motherboard
• Check the diagnostic report to determine the
faulty DIMM (see "Viewing the diagnostic
report" on page 5-18).
• When you locate the faulty DIMM, reseat the
DIMM in its socket.
• If the problem persists, insert the DIMM strip
into the other socket.
• If it fails in that location, replace it.
• Replace the motherboard.
• Replace the motherboard.