Epson Stylus Pro 5000 Service Manual page 270

4
T
O REMOVE THE
Notches
Notches
Notch guides
4-14
Service Procedures
UIB
1. Shut down the RIP Station 5000
(see "To shut down the RIP Station 5000" on page 4-2).
2. Open the RIP Station 5000
(see "To open the RIP Station 5000" on page 4-3).
3. Remove the front panel
(see "To remove the front panel" on page 4-6).
Make sure the UIB cable is removed from the motherboard connector.
4. Gently lift off the UIB enclosure. As you remove the enclosure, thread the UIB cable back
through the slot in the UIB enclosure. Set aside the UIB enclosure.
Note the placement of loose metal shielding pressed along the sides of the UIB enclosure;
if any fall off, press them back into place.
UIB enclosure
UIB cable slot
Notches
UIB
UIB cable connector
(cable not shown)
Front panel
Notch guides