Overview - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

4.1 OVERVIEW

This section explains disassembly and assembly of the printer. Basically, the
disassembled components can be re-assembled by reversing the
disassembly procedure, but we explains procedure of assembling the gear
trains for ASF control since it is complicated part. "Caution" and "Check
Point" are mentioned for the procedures which requires extra attention.
"Adjustment" is for required adjustments resulted by assembly or
disassembly. Also, read the precautions below before disassembling and
assembling in this chapter.
4.1.1 Precautions
The lithium battery, which is necessary for managing the ink system, is
mounted on the main control board of this printer. Since mishandling the
lithium battery may cause explosion at the worst case, read the warning and
caution below carefully and start disassembly or assembly.
T T
WARNING
Plug off and disconnect the power cable before
disassembling or assembling the printer.
T T
If ink gets in your eye, flush the eye with fresh
water and see a doctor immediately.
T T
A lithium battery is installed on the main board
of this printer. Be sure to observe the following
instructions.
1. Keep the battery away from any metal or
other batteries so that electrodes of the
opposite polarity do not come in contact with
each other.
2. Do not heat the battery or put it near fire.
3. Do not solder on any part of the battery.
(Doing so may result in leakage of electrolyte
from the battery, burning or explosion. The
leakage may affect other devices close to the
battery)
Rev.A
WARNING
4. Do not dismantle the battery.(The gas inside the
battery may hurt your throat. Leakage, burning
or explosion may also be resulted.)
5. Do not install the battery in the wrong direction.
(This may cause burning or explosion.)
6. Do not charge the battery. (An explosion may be
generated inside the battery, and cause burning
or explosion)
CAUTION
Remove any accessories such as paper cassettes
or tray before starting disassembly.
WARNING
Risque d'explosion si la pile est remplacée
incorrectment. Ne remplacer que par une pile du
même type ou d'un type équivalent recommandé
par le fabricant. Eliminer les piles déchargées
selon les lois et les règles de sécurité en vigueur.
Chapter4 Assembly and Disassembly
4-1