Epson Stylus Pro 5000 Service Manual page 96

Stylus Pro5000
7. Remove "E" shaped ring(#6) and one CBS screw(3x8) securing "Bush,
Parallelism, Adjustment" at the right side of mechanism, and remove
"Bush, Parallelism, Adjustment".
CAUTION
When removing "Bush, Parallelism, Adjustment",
"Reinforcing board, Axis, CR" attached behind of
"Bush, Parallelism, Adjustment" can easily come
off. Be careful not to lose this board. (Refer to
Figure4-34)
8. Remove "Axis, CR" from the notched part for "Bush, Parallelism,
Adjustment", which is removed at Step7. At this time, do not lose one leaf
spring and a plane washer.
9
CHECK POINT
When installing "Axis, CR" again, install leaf
spring(8.2x0.15x15) first, then install plane
washer(8.2x0.15x15). When installing the leaf
spring, convex side should face inside.
$'-8670(17
After removing "Axis, CR", make sure to perform
"Platen Gap Adjustment", referring to Chaper5.
"Bush, Parallelism,
Adjustment"
Figure 4-34. Back of "Bush, Parallelism, Adjustment"
Rev. A
"Reinforcing board, Axis, CR"
"Bush, Parallelism, Adjustment"
Figure 4-35. Removal of "Bush, Parallelism, Adjustment" at right side
Leaf Spring
(8.2x0.15x15)
Plain Washer
(8.2x0.15x15)
Figure 4-36. Axis, CR Removal
Chapter4 Assembly and Disassembly
"E" shaped ring(#6)
CBS(3x8)
"Axis, CR"
4-20