Epson Stylus Pro 5000 Service Manual page 24

EPSON Stylus Pro 5000
Following table shows function when the power is turned on.
Table 1-15. Functions with power on
No. Name of switch
1 Reset
2 Cleaning
3 Eject/Continue
4 Reset + Cleaning
5 Reset + Eject/Continue
6 Cleaning +
Eject/Continue
7 Reset +Cleaning +
Eject/Continue
(All SW)
Note1) :This status printing prints firmware version, ink counter, selected
code page and nozzle check patterns. Since the value of the
waste ink counter is indicated by HEX, it is recommended to use
the exclusive service program for checking the counter value.
Note2): Refer to Table1-17 for Download of Firmware and Maintenance
mode.
Rev.A
Function
Perform status printing (Refer to
Note1)
Changes paper size, type verification.
Changes platen gap adjustment for
the manual feed slots.
Changes parallel I/F ECP mode
Enters print head alignment mode.
Enters the maintenance mode,
level1.(Factory use only)
Enters the Firmware uploading mode.
(Factory use only)
Following table shows LED indications.
Table 1-16. Printer condition and Panel status
No. Printer Status
1 Power On
2 Performing Ink
sequence
3 Receiving Data
4 Paper jam
5 Cassette 1/paper out,
wrong paper feeding
6 Out of paper in
Cassette 1(paper
tray1)
7 Cassette(Paper tray)2
8 Paper out in
Cassette(Paper tray)2
9 SIMM copy error
(over flow)
10 Ink end, No I/C
11 Ink low
12 Reset, Timer IC reset,
EEPROM clear
13 Maintenance request
(waste ink counter
over flow)
14 Fatal error
Note): "---" means no changes.
Chapter1 Product Description
Indicators (Figure 1-2)
H AB D C
EF
On --- --- ---
blink --- --- ---
blink --- --- ---
--- --- blink blink blink
--- --- --- blink
--- --- --- On
--- --- --- --- On
-- --- --- --- On
blink On On On On
--- On --- ---
--- blink --- ---
--- On
(1 sec.)
blink All blink blink blink
On
blink All blink blink blink
blink
Priority
G No.
--- 9
--- 6
--- 8
3
--- 5
--- 5
5
5
4
--- 7
--- 7
---
2
1
1-12