Epson Stylus Pro 5000 Service Manual page 174

Stylus Pro5000
Step14. Printing sample as it is shown in the figure5-46 is output.
(After printing is completed screen returns to the screen of
figure5-44)
N o r m a l D o t B i - D D a t a = - 2 0
N o r m a l D o t B i - D D a t a = - 1 8
N o r m a l D o t B i - D D a t a = - 1 6
M i c r o D o t B i - D D a t a = - 2 0
M i c r o D o t B i - D D a t a = - 1 8
M i c r o D o t B i - D D a t a = - 1 6
S u p e r M i c r o D o t B i - D D a t a = - 2 0
S u p e r M i c r o D o t B i - D D a t a = - 1 8
S u p e r M i c r o D o t B i - D D a t a = - 1 6
Figure 5-46. Bi-D Printing Sample(Example)
Rev. A
Step15. Tendency of changes for the parameter and printing samples
is seen as following, by referring to figure5-46.
• Parameter is small:
• Parameter is big:
Step16. Select "Adjustment" on the screen of figure 5-44 and input
the parameter value that you think most appropriate to the
center values of 3 printing samples for each dot size,
referring to figure5-46.
M o d e s e l e c t i o n o f B i - d a d j u s t m e n t
N o r m a l D o t
M i c r o D o t
S u p e r M i c r o D o t
E S C : R e t u r n
Figure 5-47. Selecting Dot Type
Step17. Select dot type which you wish to adjust, or select all in order,
referring to each 3 types of printed results in the figure 5-46.
Chapter5 Adjustment
Even lines move to left
direction.
Even lines move to right
direction.
E N T E R : D e t e r m i n e
5-30