Unpacking The Rip Station - Epson Stylus Pro 5000 Service Manual

2
T
O UNPACK THE
2-6
Preparing for Installation

Unpacking the RIP Station 5000

The RIP Station 5000 is assembled and shipped from the factory in a box that includes
accessories, as shown in Figure 2-2 on page 2-7.
RIP S 5000
TATION
1. Open the box and remove any packing materials.
Save the original boxes and packing materials. If you need to transport the
RIP Station 5000 at a later date, the original box and packing material will ensure safe
shipment.
2. Remove the contents from the top container. Inspect the contents for visible damage.
The contents should include the following items:
• Bags containing the RIP Station 5000 cables
• RIP Station 5000 media package — containing the User Software CD and, in some
configurations, user documentation. (Obtain user documentation from your dealer if
it is not included in the media package.)
• Ethernet transceiver for 10Base2 (may not be included in your configuration)
A System Software kit containing the RIP Station 5000 System Software CD is
N :
OTE
provided separately.
3. Give the media package to the customer or the network administrator.
Let the customer or network administrator know that in order to take full advantage of
the RIP Station 5000, the user software must be installed on computers that will print to
it.
4. Set aside the remaining components from the top container.
5. Remove the top container and any packing materials.
Note the orientation of the RIP Station 5000 inside the shipping container in case you
need to repack it later.
6. Carefully lift the RIP Station 5000 out of the box.
If you notice shipping damage to any RIP Station 5000 component, be sure to save the
shipping container in case the carrier needs to see it. Call the carrier immediately to
report the damage and file a claim, then call your authorized service/support center. Be
ready to furnish the serial number, printed on the bottom of the chassis.