Epson Stylus Pro 5000 Service Manual page 151

Stylus Pro5000
Step5. Check that the model name has not been input yet, press "E"
key while pressing "Alt" key on the keyboard.
CAUTION
In the future, there is a possibility that model
name for each destination is registered on the
spare parts of EEPROM in the factory without
notice. If the correct model name appears on the
initial screen of the program after C228 DRV board
is replaced, it is not necessary to perform
following operation. So, you may go to the next
necessary adjustment.
Step6. Following screen appears to re-input the model name.
P l e a s e t y p e " S t y l u s P r o 5 0 0 0 " c o r r e c t l y !
( E n t e r k e y i s d e t e r m i n e )
> > _
Figure 5-7. Screen after pressing "Alt" + "E" keys
Step7. Type the following model name correctly and press "Enter"
key.
Stylus Pro 5000
Rev. A
Step8. Press "Enter" key to register the character data to EEPROM.
Chapter5 Adjustment
5-7