Epson Stylus Pro 5000 Service Manual page 277

4
Removing and replacing circuit boards
T DIMM
O REPLACE A
1. To release a DIMM, push outward on the levers on each side of the DIMM. (See
Figure 4-15.)
Lever
F 4-15
IGURE
2. Slide the DIMM straight out of the socket.
3. To install a DIMM, slide it straight into the socket and close the levers on each side to
lock it into place.
Make sure that the levers close securely around the ends of the DIMM and that the
DIMM is fully seated in its socket. Avoid flexing the motherboard while you firmly seat
the DIMM in its socket.
If you removed a DIMM completely, note that it fits the socket only one way. The two
notches on the bottom of the DIMM should line up with the notches in the socket.
4. If you removed the front panel from the center frame, reattach it
(see "To install the front panel" on page 4-7).
5. Reassemble the RIP Station 5000 and verify functionality
(see "Restoring functionality after service" on page 4-11).
If the Software not authorized screen appears on the Control Panel, see "Software not
authorized screen" on page 4-48.
DIMM
Releasing a DIMM
Lever
Socket notches
4-21