Epson Stylus Pro 5000 Service Manual page 285

4
Power supply
Center frame
(mounted components
not shown)
F 4-21
IGURE
5. Remove the 6-wire power cable from motherboard connector J16.
6. Remove the 4-wire power cable from the HDD.
7. Remove the 2-wire power switch cable and the grounding wire from the power supply.
Use needlenose pliers to remove the grounding wire from the ground pin on the power
supply.
8. Remove the four screws that secure the power supply to the center frame.
Hold the power supply against the center frame while you remove the last screw. Set aside
the screws for reassembly.
9. Remove the power supply from the center frame.
Note that the center connector on the power harness connects to the power supply.
Ground cables
AC power
Slots on main EMI shield
Cutouts and tabs on bottom EMI shield
Removing the power supply
cable
Power harness
cable to HDD and
motherboard
4-29