Epson Stylus Pro 5000 Service Manual page 128

Stylus Pro5000
12. Set the rib of "Gear,32" to the axis so that the rib faces outside. At this
time, 2 holes on the "Gear,32" should match with 2 holes on the "Frame,
Assembly, Middle, Right". (Refer to Figure4-98)
13. Attach "E" shaped ring. (Refer to Figure4-98)
9
CHECK POINT
In case of removing "Gear,32", since there is
phase between "Gear,32" and "Combination
Gear,18.44,24", refer to Figure4-98 and make
correct phase(engagement). Also, when setting
"Gear,32", set it so that its ribs on the gear
surface indicate 10:35, like a clock.
(Refer to Figure4-98)
14. Set a washer (black) on the same axis. (Refer to Figure4-99)
Rev. A
"E" shaped ring"
Make phase with
"Combination Gear,18.144,24". "Combination Gear,
Figure 4-98. Setting "Gear,32"
Washer(Black)
Figure 4-99. Setting a Washer(black)
Chapter4
"Gear,32"
Set ribs on the surface
at 10:35 position.
18.144,24"
4-52