Restoring Functionality After Service - Epson Stylus Pro 5000 Service Manual

4

Restoring functionality after service

Restoring functionality after service
T RIP S
O REASSEMBLE THE
1. Reseat all devices, boards, cables, connectors, and other parts that you loosened or
removed during inspection or service.
2. Place the chassis cover such that it is open at the top.
3. If not already done, attach the front panel to the center frame
(see "To install the front panel" on page 4-7).
Make sure the UIB cable is attached firmly to the UIB and that the UIB enclosure is in
place with the UIB cable threaded through the UIB cable slot in the enclosure. Make sure
the UIB cable is firmly attached to the motherboard connector J4. Make sure the center
frame is attached to the front panel with the four screws previously removed.
4. Hold the front panel / center frame assembly above the open chassis cover and then
lower it gently into the chassis cover.
Fold in the fan wires and power harness, if necessary, to avoid interfering with the
N :
OTE
closure and fraying the wires. See Figure 4-3 on page 4-4.
F 4-9
IGURE
5000
TATION
Reassembling the RIP Station 5000
4-11