Hp Sensor Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000
7. Install "Lever, PE, Sensor, B" to "Paper Guide, Upper", as it is shown in
the Figure4-67. (Refer to Figure4-67)
8. Re-install 10 small screws on the "Frame, Main, Rear" and 9 "Torsion
Spring, 189", and combine "Frame, Main, Rear" and "Paper Guide,
Upper" and complete "Paper Guide, Upper".

4.2.5.19 HP Sensor Removal

1. Remove "Housing Upper". (See section 4.2.1)
2. Remove a connector(white, 3-pin) from "HP Sensor".
3. Release 2 hooks of "HP Sensor" and remove "HP Sensor" from the
mechanism. (Refer to Figure4-68)
Rev. A
Chapter4 Assembly and Disassembly
Installing edge of
torsion spring.
2 dimples for positioning
"Lever, PE, Sensor, B"
torsion spring.
Figure 4-67. Installing "Lever, PE, Sensor, B"
Connector
"HP Sensor"
Figure 4-68. HP Sensor Removal
4-36