Tools - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

4.1.2 Tools

Use only specified tools to maintain quality of the printer.
Table 4-1. Required Tools
Name
Phillips Screw Driver (No.1)
Phillips Screw Driver (No.2)
Minus Driver (−)
Cutting pliers
Thickness gauge set
Tweezers
Exclusive pliers for C-ring for
shaft ST-0
Exclusive pliers for C-ring for
shaft ST-1
Paper pick up detector adjust
tool
Positioning pin
Torque Wrench
4.1.3 Screws
Following abbreviation for screws are used in the explanation for
disassembly and assembly.
Table 4-2. Screw Abbreviation
Abbreviation
CBS
CBP
CP
CB
Rev.A
Supplier EPSON parts code
EPSON B743800400
EPSON B743800200
EPSON B74300100
Commercially
available
EPSON B776702201
EPSON B741000100
EPSON 103983900
EPSON 103984000
EPSON 103983200
Commercially Use nail whose
diameter is φ1.8∼2.
available
EPSON B765106901
Name
Cross/Bind/S-tight screw
Cross/Bind/P-tight screw
Cross/Pan-head screw
Cross/Binding Screw
4.2 DISASSEMBLY
This section describes disassembly procedure until mechanism and "MB
Rear Unit" are removed. Refer to section 4.3 to disassemble more fine parts
on the mechanism. Refer to flow chart below for items explained on
section4.2.
−
Start
4.2.1
"Housing Upper"
Removal
4.2.2
"Housing Front"
Removal
4.2.3
"Mechanism Unit"
Removal
CAUTION
Chapter4 Assembly and Disassembly
4.2.4
"MB Rear Unit"
Removal(C228 Main)
Figure 4-1. Flowchart of Disassembly
T T
The MB rear unit, which C228 main board is
mounted on, can be removed directly, without
disassembling other parts in advance.
T T
Refer to sections from Section 4.3 for
disassembly and assembly which are not
mentioned on the flow chart above.
4-2