Activity Light - Epson Stylus Pro 5000 Service Manual

3
Using the Control Panel

Activity light

The activity light indicates the current RIP Station 5000 activity. If the light is:
Solid red
Flashing red
Solid green
Flashing green
No light
Buttons
Line selection
buttons
Up and down
button
Menu button
The RIP Station 5000 has just been powered on and is about
to begin start-up diagnostics or else there is an error that
prevents the RIP Station 5000 from processing or printing.
There is an error causing printing to be disabled, but the
RIP Station 5000 is still processing. If the error is cleared, the
light changes to green; if the error is not cleared, the light
changes to solid red when it is finished processing.
The RIP Station 5000 is idle.
The RIP Station 5000 is performing start-up diagnostics,
processing or printing a job, or communicating with a
remote computer—for example, through the Fiery Spooler.
The RIP Station 5000 is off or the user has entered
Diagnostic Test Set Selection mode on power up.
There are four line selection buttons on the right side of the
Control Panel. Use these buttons to select the command
displayed on the corresponding line of the display window. A
special character appears in the display window next to a
button when it is active.
Use this button to scroll to different screens in multi-screen
lists, to select Setup options from a list, and to select
alphanumeric characters.
Press this button to view other display screens. There are
several different display screens, showing different types of
information about the RIP Station 5000.
3-11