Procedures For Disassembly And Assembly; Removal Ofthe Video Controller Section; Video Controller Board (C125 Main Board) Removal - Epson ActionLaser 1600 Service Manual

Procedures for Disassembly and Assembly

This section describes and illustrates the procedures for removing and
disassembling the components of the ActionLaser 1600. Cleaning is described in
Chapter 6. Assembly procedures are not described, except for special notes where
necessary, because assembly can be done by performing disassembly in reverse.
Removal of the Video Controller Section
The control section is comprised of the video controller board (the C125 MAIN
board) and the control panel board.

Video Controller Board (C125 MAIN Board) Removal

Before you remove the video controller board, make sure that you remove any
optional cards or cartridges. Otherwise, you may damage the cartridge or card
connectors on the board as well as the cartridge or card itself.
1. Turn the printer so that its left side faces you,
Remove the 2 SCB (M3 x
2.
pull off the cover.
Remove the 3 SCB(S)(P1) (M3 x 6) screws that secure the metal bracket on the
3.
left side of the printer.
Figure 3-1. Removing the Interface
Cover
4. Pull the tab on the bottom of the bracket to release the video controller board,
as shown below.
EPSON ActionLaser 1600 Service Manual
Caution
screws securing the interface card cover; then
14)
Figure 3-2. Removing the 3 Screws
Disassembly and Assembly
3-7