Epson Stylus Pro 5000 Service Manual page 116

Stylus Pro5000
Step. B Cover "Gear, 27.6" on "Clutch, Lifter", hanging the leg of
"Torsion Spring, 1.77", which is bent right angle, to one hook
located on the back side of "Gear,27.6". (Refer to Figure4-75)
Step. C After covering "Gear,27.6" to "Clutch, Lifter", make them go
over the hooks, which is located both gear inside.
(Refer to Figure4-76)
CAUTION
As it is shown in Figure4-76, rotate "Clutch, Lifter"
to yellow arrow direction and "Gear,27.6" to red
arrow direction, then make them go over each
other's hook.
Rev. A
Chapter4 Assembly and Disassembly
The tip is bent
right angle.
Figure 4-75. Connecting "Gear,27.6" and "Clutch Lifter"(1)
Hooks of both gears
"Gear, 27.6"
"Clutch, Lifter"
Figure 4-76. Connecting "Gear, 27.6" and "Clutch Lifter"(2)
Hook on the back
side of "Gear,27.6"
4-40