Rated frequency range Input frequency range parallel interface Rated current Power consumption Note: Check the label on the back of the printer for your printer’s voltage. front edge guide paper tray Note: extension Some printers come with a paper guide roller in the paper tray.
Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot attest to the quality of any non-EPSON brand or type of paper. Always test samples of paper stock before purchasing large quantities or printing large jobs.
The print capacity may vary, depending on how often you run cleaning cycles. ** Ink thaws and is usable after approximately 3 hours at 77 °F (25 °C). Caution: To ensure good results, use genuine EPSON ink cartridges. Other products may cause damage to your printer not covered by EPSON’s warranty.
Safety Approvals Safety standards UL 1950, CSA C22.2 950 FCC part 15 subpart B class B CSA C108.8 class B 4 - EPSON Stylus Pro 5000 Interfaces Parallel interface The built-in parallel interface supports compatibility and ECP modes Compatibility mode...
Recommended Apple System Peripheral-8 serial cable cable: (preferably Belkin brand) EPSON Stylus Pro 5000 Accessories Ink Cartridges Use these EPSON ink cartridges before the expiration date on the package. Cartridge Part number Black ink cartridge S020118 Cyan ink cartridge S020147...
6 - EPSON Stylus Pro 5000 Running a Printer Check magenta You can use the printer check to make sure that your printer is and yellow operating correctly. Running the check before you connect the ink out lights printer to the RIP verifies that the printer itself is functioning.
Caution: Never turn off the printer when the P Operate light is flashing. However, if the light is still flashing after 15 minutes and the printer is not moving or making noise, you may turn off the printer. The P Operate process is finished.
Caution: To ensure high quality printing results, use genuine EPSON cartridges and do not refill them. Other products may cause damage to your printer not covered by EPSON’s warranty. Always leave the empty cartridge installed in the printer until you are ready to replace it with a new one.
This helps all users to be aware of what’s in the printer at a glance, and also prevents anyone from inadvertently changing the lever positions.
10 - EPSON Stylus Pro 5000 To run a cleaning cycle: 1. Make sure the printer is on and the H ink out lights are off. If any of the H ink out lights are on or flashing, you must replace the corresponding ink cartridge(s) before you can run a cleaning cycle.
[ Operate into the printer. 2. Turn off the printer and make sure the print head is in the home (far right) position. If it’s not, turn the printer back on, wait until the head stops moving and is in the home position, then turn off the printer.