Epson Stylus Pro 5000 Service Manual page 80

Stylus Pro5000
5. Insert a minus driver to 3 airspace (A), located upper paper eject of
"Housing Front Unit", and remove hooks which are connecting "Housing
Upper" and "Housing Front Unit". (Refer to Figure 4-5)
6. Insert a minus driver to 2 airspace (B), located both right and left of the
front printer and remove the hooks which are connecting "Housing
Assembly Upper" and "Housing Lower". (Refer to Figure 4-6)
7. Release one hook connecting with "Housing Lower" at the rear side of
"Housing Assembly, Upper". (Refer to Figure4-7)
WARNING
If you try to remove "Housing Assembly, Upper"
forcibly from the front direction, the rib located
inside of "Housing Assembly, Upper" may be
broken. So, be careful of removing it.
8. Remove "Housing Assembly Upper", lifting it up.
3 Hooks
Housing Front Unit
Figure 4-5. Location of Hooks
Rev.A
Chapter4 Assembly and Disassembly
Housing Upper
Housing Front Unit
Figure 4-6. Position of Hooks(located both right and left side)
One hook on the
"Housing Assembly,
Upper".
Figure 4-7. One hook at back of the printer
2 Hooks
4-4