Preface
About this guide
The Installation and Service Guide is intended for certified RIP Station 5000 service
technicians installing or servicing a RIP Station 5000 PostScript
received installation and service certification, you should not attempt to install or service
a RIP Station 5000 PostScript server. Electronics for Imaging, Inc. does not warrant the
performance if installed or serviced by non-certified personnel.
About this guide
This guide is divided into the following sections:
• "Preface"
Gives general information about this guide and about installing the RIP Station 5000.
• Chapter 1, "Introduction"
Provides general information about the RIP Station 5000.
• Chapter 2, "Preparing for Installation"
Describes unpacking and the steps you need to take before you install the unit.
• Chapter 3, "Connecting the RIP Station 5000"
Describes how to connect the RIP Station 5000 to the printer and the network and
verify that the system is working correctly. This chapter also gives an overview of the
Control Panel.
• Chapter 4, "Service Procedures"
Describes removal and replacement procedures for RIP Station 5000 components.
• Chapter 5, "Troubleshooting Procedures"
Identifies the source of common problems and suggests ways of correcting them.
RIP Station 5000 customers should not use the technical service documentation. Please
don't leave your copy of the Installation and Service Guide behind after you make a service
call.
About the illustrations in this guide
The illustrations in this guide may not reflect the current shipping version of the
RIP Station 5000 at the time of publication. Components shown in these illustrations
are subject to change. To receive information about any RIP Station 5000 components
that do not match illustrations in this guide, contact your authorized service/support
center.
®
server. If you have not
ix