Mechanism Unit Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

4.2.3 Mechanism Unit Removal

1. Remove "Housing Upper". (See section 4.2.1)
2. Remove "Housing Front Unit". (See section 4.2.2)
3. Looking from back side of printer, insert the plus screw driver into the
notch which is located at "Frame, Main, Rear" and remove 2 CBP
screws(4x12) securing the mechanism to "Housing Lower".
(Refer to Figure4-10)
4. From the printer front, remove 2 CBP screws(4x12) securing the
mechanism to "Housing Lower". (Notice that the fixing screw at the left
side is also securing reinforcing frame.)
WARNING
When installing the mechanism to "Housing
Lower", it is recommended to do so by 2 service
men. And connect 2 waste ink tubes of right and
left head into each holes of waste ink absorber.
Failing to do so causes ink leaking.
9
CHECK POINT
When installing the mechanism to "Housing
Lower", install them matching 2 dimples of
"Housing Lower" to 2 notched parts on the
mechanism frame, as it is shown in the figure 4-
11.
5. Lift up the mechanism and remove it from "Housing Lower".
Rev.A
Chapter4 Assembly and Disassembly
"Frame, Main, Rear"
Notched parts
to insert the driver
Figure 4-10. MB Rear Unit Removal (1)
Positioning Notches
Reinforcing Frame
2 CBP screws(4x12)
Figure 4-11. Mechanism Removal (2)
4-6