Epson Stylus Pro 5000 Service Manual page 154

Stylus Pro5000
Step9. Select "Head Voltage ID Input" and press Return.
Step10. Following screen appears.
H e a d a c t u a t o r v o l t a g e I D a d j u s t m e n t
C h e c k i n g a p r e s e n t d a t a
C h a n g i n g a d a t a
E S C : R e t u r n U P / D O W N : S e l e c t E N T E R : D e t e r m i n e
Figure 5-11. Checking Head ID/Writing ID
Step11. If you need to check the current data according to the content
of Table5-3, select "Checking a present data" and press the
Return key. If you want to write new data, select "Changing a
data" and press Return key. Following shows each screen
for each case.
R e a d i n g o u t a h e a d a c t u a t o r I D
L e f t h e a d a c t u a t o r I D
R i g h t h e a d a c t u a t o r I D = I 1 F K K C
E S C : R e t u r n
Figure 5-12. Checking Present Data
Rev. A
= I 1 E L J M
C h a n g i n g d a t a
L e f t h e a d
R i g h t h e a d
E S C : R e t u r n U P / D O W N : S e l e c t E N T E R : D e t e r m i n e
Figure 5-13. Data Change
Step12. In case of selecting "Checking a present data", make a note
of each right and left head ID, as it is shown in the figure5-12.
Then, press ESC key and return to the previous screen.
Select "Changing a data" and write ID, which you made a
note of it, after replacing C228 DRV board.
Step13. In case of selecting "Changing a data" from the beginning,
(head replacement), make a note of head ID, which is written
on the top of the head, and input those values for each
right and left head ID.
Chapter5 Adjustment
5-10