Epson Stylus Pro 5000 Service Manual page 173

Stylus Pro5000
Step10. Following screen appears.
B i - d i r e c t i o n a l a d j u s t m e n t
P r i n t o u t B i - d p a t t e r n
A d j u s t m e n t
C h e c k i n g a p r e s e n t a d j u s t m e n t d a t a
E S C : R e t u r n U P / D O W N : S e l e c t E N T E R : D e t e r m i n e
Figure 5-44. Main Menu for Bi-D Adjustment
Step11. Select "Print out Bi-D pattern".
Step12. Following screen appears.
P r i n t o u t a B i - d p a t t e r n b y p r e s e n t d a t a
N o r m a l D o t : p r e s e n t d a t a - 2 , p r e s e n t d a t a , p r e s e n t d a t a + 2
M i c r o D o t : p r e s e n t d a t a - 2 , p r e s e n t d a t a , p r e s e n t d a t a + 2
S u p e r M i c r o D o t : p r e s e n t d a t a - 2 , p r e s e n t d a t a , p r e s e n t d a t a + 2
E S C : R e t u r n
Figure 5-45. Screen After Selecting "Print out Bi-D pattern"
Rev. A
E N T E R : D e t e r m i n e
CAUTION
The message on the screen of figure5-45 means to
adjust 3 printing patterns for 3 dot types
respectively ; normal, micro and super micro dot,
taking offset of the present head gap adjustment
value. Therefore, if the center value "0" is already
input, you can check the 9 printing sample
patterns, based on − − 2, 0, and + + 2 adjustment
values.
Step13. Press Return key. (During printing, the message, "Bi-D
pattern is being printed out now" appears on the screen)
Chapter5 Adjustment
5-29