Epson Stylus Pro 5000 Service Manual page 137

Stylus Pro5000
Step.G Insert a positioning pin into "Combination Gear,24,24" and
push it gradually toward the hole on the frame. On the way,
set "Combination Gear,24,24", engaging the teeth of
"Gear,11" and "Gear,10", and fix then by "E" shaped ring.
(Refer to Figure4-115)
9
CHECK POINT
After arranging phase of "ASF Unit", the
protrusion part of "Roller, Paper Feed" should be
up. If the phase is arranged in the condition that
protrusion of "Roller, Paper Feed" faces down,
remove "Gear,24" and "Combination Gear,24,24"
once, and arrange phase again in the condition
that protrusion faces up.
35. Rotate "Roller, Paper Feed" on the "ASF Unit" as it is shown in Figure4-
116. (We call this condition of "Roller, Paper Feed" as it is shown in
Figure4-116 Hopper State .)
9
CHECK POINT
The reason why to keep "ASF Unit" in the
condition shown in Figure4-116 is to install it into
the main unit easily.
Rev. A
Chapter4 Assembly and Disassembly
"Gear,10" already fixed
at StepB.
"Gear,11"
"Combination Gear,24,24"
Figure 4-115. Fixing "Combination Gear,24,24"
Rotate flat side to the printer body side.
Figure 4-116. Preparation Before Installing "ASF Unit"
"Gear,24"
already fixed at
StepD.
4-61